![]() ![]() The Savant App generates a Network Unreachable Error when the Savant Host is having trouble communicating with the local Wi-Fi network. This section provides resolutions to common networking errors. The Remote Base and IR Blaster communicate with the controlled devices (Television, Apple TV, etc.) using IR.The Remote Base communicates with the IR Blaster over Bluetooth.The Remote communicates with the Remote Base over Bluetooth.Each Savant Device (Remote Base, Lamp Control) communicates with the Savant Host.The Savant App on the iOS or Android device communicates with the Savant Host over the local Wi-Fi network.Refer to the diagram below when troubleshooting. ![]() of the iOS or Android device running the Savant App.īelow is a network diagram showing the Savant 1.x entertainment package. During initial setup or when adding devices to the network, ensure that any devices being added are within 30 ft.The IR Blaster communicates with the local Wi-Fi network through the Remote Base.Each device added can now communicate with the Savant Host over the local Wi-Fi network.The User now adds each additional device using Bluetooth to the local Wi-Fi network through the Savant App.The Host can now communicate with the local Wi-Fi network.The iOS or Android device communicates with the Savant Host using Bluetooth through the Savant App and provisions the Host to the local Wi-Fi network.Locate Device Status LEDs and Reset Buttonsīelow is a network diagram showing the setup process. The device is responding to a Locate command sent to it from the Savant App. In this state, the device is ready to be added to a local Wi-Fi network. After the reset, the rapid red blink will stop change to solid yellow, and then to a slow blinking yellow. The device has been reset and will return to its factory default settings. Do Not unplug the device until the software update is complete. The device is receiving a software update over the local Wi-Fi network. If the blinking remains constant, the device is connected to the local Wi-Fi network but not the Savant Host. The device is connecting to your network and establishing communication with the Savant Host or Savant App. The device is ready to be connected to the local Wi-Fi network The device has established communication with both the local Wi-Fi network and Savant Host. More than 1 minute – Device can't locate the Wi-Fi network it was formerly connected to. The state will change once boot is complete. The Savant 1.x products use the following codes on their LED status lights. Host communicates with the IP Cloud using port 443.Sonos speakers communicate with host using port 3401.Multicast packets are broadcast on port 1900. ![]()
0 Comments
Leave a Reply. |